Plaster-based powder coating containing calcium carbonate, resin and various additives.
The mixed paste is white in colour.
All types of plasterboard with or without insulation (glass wool, rockwool, polystyrene) with tapered edging and plasterboard surfaces.
• Sealing undercoat for plasterboard
• Plaster-based smooth finish coating
DTU 25.41 and DTU 25.42. NF EN 13963.
• Setting time: 1 hour
• Tape adhesion: > 1000 g
• Cracking: no cracking up to 5 mm thickness
• Density: 0.9
• Reaction to fire: A1
25 kg bags on shrink-wrapped pallet.
5 kg bags on shrink-wrapped pallet.
9 months in unopened original packaging stored away from moisture.
The plasterboards must be fixed in accordance with DTU 25.42.
Cuts in boards must be bevelled and free from dust.
10 to 11 litres of water per 25 kg bag.
Before treating the joints themselves, cover edges between accidentally non-abutting panels and various fillers (spalls, deterioration in cladding, etc.)
Apply manually by “buttering” the tapering using a 10 or 15 cm filling knife and positioning the tape. (ground surface against the coating).
Then make a finishing pass, allow to dry and finish to mask the tape.
Also mask the screw heads.
Apply a tape in the ceiling, ensuring that the concrete shows no trace of form oil.
If there are vertical angles projecting, use a reinforced tape (frame arrange on the complex side) or a metal angle section.
Approx. 350 g/m² of boards.
Can be repeated 4 hours after application of the first pass.
To avoid the formation of “lint”, do not rub down plasterboard before the sealing undercoat.