KEDOCOL SUPER BLANC

KEDOCOL SUPER is a class C1 adhesive mortar for laying ceramic earthenware and mosaic tiles in traditional sizes on interior walls and floors.

Grey or white cement, sand, resin and various additives.

• Cement render (2000 cm²)
• Rough mortar render (2000 cm²)
• Plasterboard (1100 cm²)
• Concrete slab (2000 cm²)
• Cement screed (2000 cm²)
• Levelling compound (2000 cm²)

Technical prescriptions book (CPT) by CSTB.

• Pressed or drawn sandstone (enameled or not)
• Pressed or drawn earthenware (enameled or not)
• Porcelain
• Mosaic
• Stone cladding
• Reconstituted stone, marble (Use KEDOCOL SUPER WHITE)

• Adhesive dry : > 0.5 MPa
• Adhesive after action of water : > 0.5 MPa
• Adhesive after freezing/immersion cycles : > 0.5 MPa
• Mixing rate : 30%
• Practical working time : 4 hours
• Time open : 30 min
• Time of adjustment : 20 min
• Waiting time before grouting of joints : 24 hours
• Time before putting into service : 24 hours

5 and 25 kg bags.

6 months in unopened original packing protected from damp.

DO NOT APPLY WHEN THE TEMPERATURE IS BELOW 5°C OR TO FROZEN SUBSTRATES.
DO NOT EXCEED THE ADHESIVE OPEN TIME.
FOR NATURAL STONE WITH POROSITY < 5% AND FULLY VITRIFIED EARTHENWARE TILES, PROCEED BY A DOUBLE APPLICATION OF ADHESIVE.
FOR APPLICATION TO A SUBSTRATE WITH A FLATNESS VARIATION EXCEEDING 7MM UNDER A 2M RULE FIRST APPLY OUR KEDOPLAN P3 LEVELLING COMPOUND.
DO NOT APPLY TO PLASTER OR TO A THIN COAT OF FILLER.

Comply with the substrate drying times: 48 hours for cement filler, 2 months after completion of carcass work for new concrete substrate.

In all cases, the substrates must be sound, clean, free of traces of oil and dust, and mechanically strong.

The temperature of the substrate shall be not less than 5°C or greater than 35°C.

In hot weather or if the substrate is exposed to the sun, or if it is too porous, dampen or apply our PRIM S.M. primer. 

Local unevenness defects can be smoothed with KEDOCOL SUPER GRIS up to an 8 mm limit.

Consumption depends on the application method and tool. In general, it is as follows :

Single application: 2.5 kg/m².

Double application: 4 kg/m².