FIBREXTER

Cement-based powder filler with fibres for treating damaged exterior substrates.

The filler is multi-purpose: can be used to fill, repair and rectify wall surfaces, with a smooth finish.

Compound in powder form, composed of cement, sand, calcium carbonate, resin, fibre and various adjuvants.

The resulting paste is white.

All types of substrates : cement, concrete, concrete blocks, stones, brick, old paintwork, old tiling.

Once the filler is completely dry, can be covered with all types of coatings and paintwork.

Do not directly cover with solvent-borne paint.

• Setting time: 30 to 40 minutes

• Adhesion: complies with EN 16566

• AFNOR NFT 36.005 classification: Family IV class 4c

5 - 15 kg bags on covered pallet.

6 months in original unopened packaging in a dry place.

Do not use paste that has begun to set. Do not apply on damp substrates Not suitable for the treatment of in-ground walls. Do not apply to floors.

The temperature on application and during drying must be between 8 and 35°C.

Dangerous, follow the instruction for use.

Contains cement: wearing gloves is recommended.

Refer to the safety labelling on the packaging. Follow the caution advice.

Safety data sheet available on www.quickfds.com, read it before using.

• 6 to 6.5 litres of water per 15 kg bag

• 2 to 2.2 litres of water per 5 kg bag

• 0.4 - 0.43l of water for 1 kg

• 2 volumes of water for 5 volumes of powder

Application with a plastering spatula, knife, smoothing trowel. Clean tools with water.

All thicknesses.

Approximately 1 kg per m²/mm of thickness.

It depends on the ambient conditions, the type of substrate and the thickness of application.

A second coat can be applied 12-24 hours after the first coat under normal conditions.

Open up cracks.

Ensure the substrate is perfectly hard and sound and if necessary use a primer to harden the substrate.

Adapt the consistency of the filler to the type of work.

8 to 35° C